Journal of Applied Research in Electrical Engineering

Journal of Applied Research in Electrical Engineering

Efficient Coefficient Estimation of Polynomial Phase Signals: A Novel FFT-Free Filtering Method

Document Type : Research article

Authors
1 Fiber Optics group, Institute of Science and High Technology and Environmental Sciences, Graduate University of Advanced Technology, Kerman, Iran
2 Electrical and Computer Engineering Department, Graduate University of Advanced Technology, Kerman, Iran
Abstract
The polynomial phase signal (PPS) model is widely utilized in various communication systems, with the estimation of its phase polynomial coefficients being a primary objective for parameter estimation. Noise is a significant source of error in PPS coefficient estimation; therefore, enhancing the signal-to-noise ratio (SNR) of PPSs is crucial for achieving more accurate coefficient estimates. This paper presents a novel filtering algorithm for PPSs that leverages sub-signal filtering and combination techniques. The sub-signal filtering employs a fast, FFT-free frequency estimation method based on phase difference averaging (PDA), de-chirping, and a moving average filter. Following sub-signal filtering, the combination of sub-signals through averaging in overlapping regions further improves the SNR. Also, for selection of optimal sub-signal length, a new optimality criterion is proposed. Theoretical analyses and simulations demonstrate that this algorithm achieves acceptable accuracy with reduced complexity compared to FFT-based methods. Additionally, when estimating the phase polynomial coefficients, the proposed filtering algorithm, combined with phase unwrapping and least-squares estimation, can achieve a mean square error (MSE) that is lower than or equal to that of the superior QML method, while significantly reducing computational complexity.

Highlights

  • A novel filtering algorithm for polynomial phase signals (PPS) based on sub-signal filtering and combination techniques is proposed.
  • The sub-signal filtering employs Phase Difference Averaging (PDA), de-chirping, and a moving average filter.
  • For the purpose of achieving low computational complexity, the use of DFT in frequency estimation is avoided.
  • Two averaging steps: intra-subsignal and inter-subsignal averagings are used for further noise filtering.
  • The proposed filtering method can be used prior to polynomial coefficient estimation algorithms to enhance the results significantly.

Keywords
Subjects

Volume 4, Issue 2
Summer and Autumn 2025
July 2025
Pages 242-253

  • Receive Date 07 April 2025
  • Revise Date 30 December 2025
  • Accept Date 25 February 2026